How do I install a flash memory module?
1. Start by saving your configuration to Alarmware.
2. Press the "Power Off" key on the front panel.
3. Disconnect the battery and unplug the main power cord.
4. Open the Catalyst cover.
5. Install the two plastic supports on the "System Board."
6. Take the Flash memory board and line it up with the connector.
7. Make sure all the pins are lined up correctly and press down until completely seated.
8. Install the support screws and tighten.
9. Reconnect the battery.
10. Close the Catslyst cover and reconnect the power cord.
11. The Catalyst will automatically POWER ON and reformat the file system.
12. Reconnect to Alarmware and export the configuration to re-load the Catalyst.