Verbatim Gateway
      Back to home
      1. Support Center
      2. Verbatim Gateway

      Verbatim Gateway - How do I disarm a single remote channel without disarming the entire alarm system?

      How do I disarm a single remote channel without disarming the entire alarm system.  

      Verbatim Gateway Owner's Manual

      F.10.2 Remote Channel Alarm Criteria

       

      4 5 ZZ

      Function Read alarm criteria for channel ZZ

      Response remote channel <ZZ> <criteria> or remote channel <ZZ> no

      net address programmed

      • Note: By reading the channel alarm criteria first it will be easier to restore its original programming later.

       

      4 5 ZZ 0

      Function Disarms <ZZ> (i.e. eliminates all status reporting for the

      channel). All other configuration information is preserved.

      Response remote channel <ZZ> disarmed

       

      Here are some possible choices when you are ready to rearm the input.

       

      4 5 ZZ 1

      Function Set channel number ZZ alarm criteria to normally 1.

      Response remote channel <ZZ> normally 1

       

      4 5 ZZ 2

      Function Set channel number ZZ alarm criteria to normally 0.

      Response remote channel <ZZ> normally 0

       

      4 5 ZZ 3

      Function Set channel number ZZ alarm criteria to no alarm. The channel

      is still listed in all status reports.

      Response no alarm condition for remote channel <ZZ>